No, there is no limit, so you and your family can all connect to the extended Wi-Fi signal no matter where you are in your home.

Yes! Unlike your router, RangeXTD does not have to be plugged into a phone jack, so you can relocate it to any outlet in your home at any time!

RangeXTD works with computers, laptops, phones, smart TVs, and more! Any model, any generation— if it connects to Wi-Fi, it can connect to RangeXTD.

RangeXTD works up to 300Mbps.

Yes! With additional RangeXTDs, you can extend your wireless internet signal even further and create an even stronger connection for all your devices, but a daisy chain is not recommended.

The ideal location is halfway between your wireless router and your computer, but the device MUST be within the wireless range of the wireless router.

WPS supports WPA/WPA2 security, if your router is using WEP security you will need to reconfigure the security setup of your router to WPS.

Depending on the structure of your home and the speed of your existing router 300Mbps plus.

Theoretically, in indoor conditions, the Wi-Fi signal can extend up to 70 meters or 230 feet depending on obstructions.

The device supports WAP and WAP2 for protected setup (Wi-Fi Protected Access®: WPA-PSK, WPA2-PSK).

Firstly, check if the indicator light on the booster is blinking, the device needs a few seconds to prepare the Wi-Fi signal. Make sure your internet source is close to the device, so you are in its range, if SSID still does not show up in your Wi-Fi list, try to disable Wi-Fi on your PC or phone and enable it again. Or forget the SSID name you did the setup and then search again.

YES, Find the Reset button on the side surface of the device, then plug the device to power, and wait for a few seconds. Then press the reset button for about 3 seconds, and the device will reset.

Yes, for first-time setup, you may need to place the device closer to the router. After you’ve set up your device you can move it to a farther location.